ipconfig /renewДЄfter a few seconds, you should see the results and there should be an IP address listed next to IPv4 Address. In this case, skip down to the Reconfigure Static IP AddressВ section.ДЄfter running this command, you need to run the command to renew your IP address, which it will try to get from the DHCP server. Note that if your computer is setup with a static IP address, you will get a The operation failed as no adapter is in the state permissible for this operation error message. For Ethernet ports, youвЂ™ll see the Ethernet adapter Ethernetx heading and for wireless cards youвЂ™ll see Wireless LAN Adapter Wi-Fi or something similar. Click on Start and type in CMD.ДЄt the prompt, go ahead and type in the following command, which will release your IP address: ipconfig /releaseДepending on how many adapters you have installed on your machine, you might see several results from the command above. You can release and renew the IP address for your computer using the command prompt. Yes, that usually will fix the problem automatically! If not, then keep reading below. Firstly, go ahead and restart your computer. IвЂ™ll start with the simplest and move on. There are a few ways you can go about fixing this problem. If you have connected multiple wireless routers to your network and DHCP is enabled on more than one device.If you have multiple network adapters, it is possible for the computer to have an IP address conflict with itself.A laptop is put into sleep mode and then turned on while connected to another networkВ that has already assigned the same IP address to another computer.One computer is assigned a static IP address that falls into the DHCP range for the local network and the same address is assigned to a computer by the DHCP server.Two computers are assigned the same static IP addresses.

This problem, though rare, can occur because of the following reasons: Please reconfigure a different IP address. This IP address is already in use on the network. You may also see a different error message for the same problem: There is an IP address conflict with another system on the network

Windows 10 no ip configuration